Features of straightening machine:

　　Some parts of the straightening machine adopt maintenance-free bearings, which do not require oiling and maintenance, which is 5-8 times the service life of ordinary bearings. Mainly used for straightening and cutting of hardware industry, stainless steel, heat-resistant steel, alloy steel, low-carbon steel bar materials, without visible scratches after straightening.

　　★ The GTB series steel bar straightening and cutting machine is a new generation of high-tech products carefully developed over the years. It has outstanding features such as high efficiency, energy saving, material saving, labor saving, and reasonable structure, ranking the domestic leading level.

★1. Equipped with the world’s most advanced Delixi electronic control system, full protection for overload, underload, phase loss, short circuit, overheating, fixed-length counting, start-up, stop, and all automation. It can automatically complete straightening, cutting, counting and other work procedures, and automatically stop after the output is completed. One person can operate it, which can save workers' wages to the greatest extent.

★2. The cutting adopts hydraulic follow-up cutting technology, which not only saves a lot of tool loss, but also fundamentally eliminates the phenomenon of continuous cutting and continuous cutting. There is no short broken steel bar caused by this, and the cutting is accurate, and the waste is Zero, the material surplus rate is increased from 98% of the general straightening and cutting machine to 100%. This alone can save 20,000 to 30,000 yuan for a steel bar manufacturer with an annual output of 1,000 tons. The noise during work is extremely low, which is consistent with Environmental requirements.

★3. Straightening roller: A series of straightening machines produced by the introduction of German high-tech balancing technology (the only domestic use of this technology for the production of straightening machines), its straightening roller micro-balance degree reaches 99%, and the drum speed is general straightening The machine is 2-3 times faster than the machine at a speed of 60 meters per minute, which is 2-3 times that of a general straightening machine with the same power. The shift output can reach more than 10 tons, and the machine has low noise and low vibration when it is working. Work

★4. Process: The hyperbolic structure straightening roll is adopted to ensure that the machine can maximize the geometry and mechanical properties of the wire surface when straightening cold-rolled ribbed steel bars without damaging the ribs. It has a wide straightening range and can be straightened. ￠4mm--14mm wire, cold drawn low carbon steel wire, high strength steel wire, cold rolled ribbed steel bar, etc.

　　★5. Straightening effect: The straightening effect is good, the straightening of the overdrawn bar is high, less than 2mm per meter, and the surface is free of scratches.

★6. Energy consumption: The linear speed is 60-100 meters per minute, which is 2-3 times that of a general straightening machine with the same power. It can not only meet the needs of mass production, but the relative electricity and wages per ton of materials are only equivalent to others. One-half or one-third of the manufacturer.